Home > Antennas / Mounts > Accessories
Sort By:
Page of 2
Pre Made and Finished Mini 8 Coax Cable Jumpers 3FT-100FT

Pre Made Coax Cable Jumpers

FIRESTIK ANTENNA STUD K-4A
List Price: $9.95
Price: $7.49
Savings: $2.46

The importance of the stud mount cannot be over stressed! The antenna stud mount acts as a bridge between the antenna and the coaxial feedline. Accordingly, it needs to allow for efficient transfer of your transmitted and received signals to and from the transceiver. If the stud mount doesn't perform that task efficiently you end up with unneeded loss. And if that isn't enough, the stud mount must be strong enough to withstand all of the stress placed upon it from an antenna that is subject to severe wind load and vibration.
Firestik Antenna & Mount Protecting Springs medium duty
List Price: $16.95
Price: $9.99
Savings: $6.96

Firestik Antenna & Mount Protecting Springs
2 year Warranty
Plug to Plug Dome Assembly Stud JBC-930
List Price: $15.95
Price: $12.95
Savings: $3.00

Plug to Plug Dome Assembly Stud
Firestik Antenna & Mount Protecting Springs Heavy Duty
List Price: $16.95
Price: $13.99
Savings: $2.96

Firestik Antenna & Mount Protecting Springs
2 year Warranty
Firestik STAINLESS STEEL Meduim Combo Spring & Stud Mount
Price: $13.99

Save both space and money when you decide you want a spring under your antenna. Instead of buying a stud mount and a spring as individual components, you can buy one part and have it all.
FireStik Stainless Steel Stake-Hole Mount
List Price: $16.99
Price: $16.99

This stainless steel mount locks into any of the stake hole pockets along the edge of a pick-up truck bed. There is no need to drill any holes in the vehicle. The mount can be used on bed rails with protective covers (such as those on the newer Ford Super-Duty trucks). Because of the stud mount configuration on this mount, it can only be used on trucks where there is inside access to the stake hole pocket (from side or bottom) for the coaxial cable to be routed to the mount. In some cases, this might require that the coax be routed through an opening that is too small for a PL-259 connector to pass. In those cases, the PL-259 will need to be installed after the coax has been routed. The mount will easily support heavy-duty antennas up to 4 feet (1.2m) in length.
Wilson Heavy Duty Gumdrop Stud
List Price: $24.95
Price: $18.95
Savings: $6.00

Wilson Heavy Duty Gumdrop Stud
Ground Plane Radial Kit GRK-8
List Price: $27.95
Price: $24.95
Savings: $3.00

Ground Plane Radial Kit for Mobile or Base Antennas
  • Ground Plane Enhancement Kit
  • Comes with (1) Slip-On Collar, (8) 2' Fiberglas Radials, and Hardware.
  • Fits Bandit and Most Other CB Antennas

Hustler SSM3 Stainless Steel Heavy Duty Spring for Antennas
List Price: $28.95
Price: $25.95
Savings: $3.00

Hustler SSM3 Stainless Steel Heavy Duty Spring for Antennas